On page 48 is the oiler fitting for the cylinder. The 1/8" pipe tap should only be about 3/8" deep instead of the 9/16" shown.

If you drill it 9/16" deep you'll end up cussing when you start to turn the 45 degree. Especially if you're using the only piece of steel you have that's big enough. At least that's the way it went here.

John Schwytzer
Front page   Diff Backup Reload   List of pages Search Recent changes   Help   RSS of recent changes
Last-modified: Thu, 14 Jun 2007 23:26:21 GMT (1306d)
The Gingery Machines wiki is published under the
Creative Commons Attribution-Share Alike 2.5 License Creative Commons License